Well after evalfile usefulscripts/SetupNew.js, I get this instead of NO OUTPUT, as on video. It seems that nothing is working on my pcin terminal
git clone https://github.com/reswitched/pegaswitch
cd ~/pegaswitch
npm install
sudo node start.js
Well after evalfile usefulscripts/SetupNew.js, I get this instead of NO OUTPUT, as on video. It seems that nothing is working on my pcin terminal
git clone https://github.com/reswitched/pegaswitch
cd ~/pegaswitch
npm install
sudo node start.js
Im not sure, but u didnt must use that command anymore. I everytime skip them and starting from running the ace.
sdbcore is enabled in new pegaswitch by default, so u can skip this too.
im tired and it's hard to explain but I got alot going on i made really dumb mistake and wrote switch ip in my command
Instructions
Load Pegaswitch
Run following in Pegaswitch:
enable sdbcore
evalfile usefulscripts/SetupNew.js
Open 2 cmd promps with Admin rights and enter Bash enter following cmd in one window:
nc -v -l -p 2991
Back to pegaswitch enter:
runnro ./nros/ace.nro
Now use the other terminal window. As in video I recommend cd till you are in your nro folder from here enter:
ncat --send-only 192.168.0.2 2991 < retroarch_switch.nro
Replace my ip with yours.
1. Loaded, waited for "pipe closed",
2. Enabled sdbcore. Recieved: enabled sdbcore
3. After evalfile usefulscripts/SetupNew.js recieving this: View attachment 109775
And after this, there is no reason to continue...
Eh...as others have mentioned you must enable the running of nro I suspect. But I am sorry I have no other ideas. try this will you?
">git pull origin runnro-command
You're welcome"
I hope this helps you...courtesy of FoxofGrey
and on the terminal (ncat -klp 2991) after launch ace.nro, nothing change tooTry again. Its normal.
1. Loaded, waited for "pipe closed",
2. Enabled sdbcore. Recieved: enabled sdbcore
3. After evalfile usefulscripts/SetupNew.js recieving this: View attachment 109775
And after this, there is no reason to continue...
Read the pegaswitch documentation on their githubAfter I write runnro ./nros/ace.nro Pegaswitch terminal write unknown cmd
Do you have the nro for it?see, isn't that hard New RetroArch support MutliRom etc.
Will try, a little later. I am done for now. Need rest a little.This is clearly an issue with your Nodejs runtime. Before loading pegaswitch, what is the output of node --version ?
I recommend unistalling this nodejs version and installing the latest. Good luck.
@Nezztor Hey, do your emulator have a ROM in it? Just wanted to say, you might want to change the link to exclude it, as distributing ROMs on here is uh, well, kinda bad...? I don't know it was an oversight, and it so that's fine, just be careful
no one has a problemI was Thinking about that, but this is just a POC but if some mod have a problem with it I will remove the link shure
I was Thinking about that, but this is just a POC but if some mod have a problem with it I will remove the link shure