That did it!!!! It's working great now with the whole thing reassembled, it seems. Thanks so much all you guys for the quick responses, and especially you Doctorbeefy for the apparent solution!
Looking at it again this morning, I think that this is likely the issue. I've noticed the error code happens when the shield is full connected around the CPU and solder points, when it is loosened it works fine. I'll try removing some excess before redo-ing the whole thing.
A short was my guess as well, I can see the error code through the bottom of the case when it's put back together, it's the same code I get when I apply gentle pressure.
Long Long Short (or ==* CPU always reach BCT)
The hwfly chip I installed only has the four solder points on the flex cable...
Ah, damn. I appreciate the quick response, I'll give it another go and see if it sticks. Thanks!
Just to verify, even just light pressure on the chip hanging off to the side of the CPU solder points would affect those? It seems like when I apply pressure to the chip and get the error there...
Hi all,
I'm new to this and to these forums but I'm hoping someone can help me... I have the hwfly installed on my V1 switch and everything seems to work fine. When it's disassembled it boots into NOSD just fine, only blue lights on the chip. But as soon as I put the metal backplate on, or...
Ah, yes, portrait mode, surely the best way to film a row of people. If only there were some way to fit a wider shot, at the expense of height... if only...