I actually think I am totally wrong about the firmware version.
I think it's the ribbon cable that causes the issue and is why some consoles need 100ohm instead of 47ohm (it's caused by the ribbon cable)
I've ordered some 100ohm resistors to test the theory. But I removed the A, D, 3.3v...
So today some idiot (me) was installing a modchip on a customer's OLED and didn't pay attention to where they were clamping the board (rookie error).
So I manage to break what I think its an IC...which controls the docking and charging of the right joycon.
I've seen it on a hand drawn...
Thanks for the help!
What's the preferred modchip now? I'm thinking about swapping my installs to intinctnx....seem to have a few issues with these clone type boards
I've attached the photo of the board I'm using. I'm guessing it's the resistors next to the test points below the reset button?
Do you know what size they are off the top of your head?
Hey guys,
Bit of an amatuer installer probably done 15 or so without issue.
But this one is driving me mental, no matter what I try I can't get OFW to boot. Can create an emuMMC and boot CFW with not issues.
Restart to OFW or power + volume -/+ gives me a Nintendo logo and then nothing but a...
Only thing drive me crazy is all these new horror games nowadays is its so dark, all time. I can't even play them. I understand they trying to create spooky but be creative a little, not just darkness with pop out scare scenes.