Just try these:
Start Goldleaf -> USB Mode -> Connect Switch - > Disconnect Switch -> Connect again
Try it 2-3 Times, sometime it help....
If not, build in a power switch to your Modchip. So that after Payload the Chip go off.
Im switching between three SD-Cards, all have the same behavior (all Cards are from Sandisk, all different size, all fat32 (32kb)). The Problem can't be here....
My thoughts are, the USB Mode is different. Im not sure if the Trinket react strange or the Switch change the voltage on the...
Okay, I don't found a solution so far for the Problem. Its seems, that the Trinket get Powered over the Data(+) and Data(-) Connection and catch up the USB Data Transfer...
But I found a way to prevent this!
When i connect USB to PC and fire on Goldtree -> USB Install and Goldleaf is connected...
Hey folks,
my internal Trinket m0 (with Fusee-UF2 - THX to mattytrog) is only active, when i press a hidden button behind the backside air-grills (button is on 3v strap) and everything was working like a charm. Switch boot in RCM (autoRCM) and i just hold the button for a second to powering the...
Thank you, for the fast reply & hopefully i am not a big noob in your eyes :blush: start ironing is always a big step for me :unsure:
Maybe you could prevent a lot of insecurity for the members in your main software thread, when you build in a "Easy Installation" Guide like:
You hate iron...
THX for your work mattytrog :wub:
To be clear...
1. Get a brand new Trinket m0 chip
2. put Fusee-UF2 file on it (for ex. "TRINKET_LEGACY3_FUSEE_UF2_V2.UF2")
3. Trinket m0 is done
4. If I already have autoRCM and just want boot direct into CFW, I need the 4-wire Setup
5. put payload.bin on the...
Only thing drive me crazy is all these new horror games nowadays is its so dark, all time. I can't even play them. I understand they trying to create spooky but be creative a little, not just darkness with pop out scare scenes.