Relatively recently I decided to install a mod chip on my nephews Switch and it worked for like an hour and then it stopped working and when I tried to reboot it would get stuck at the Switch logo. Would get the error code 2002-3540. It was a...
It still boots, at least into Hekate. Beyond that it won't boot and now I get an error code about the charging system. Plus it stopped charging in Hekate. I figure I'll change the M92 and USB-C connector anyway.
I have with no good results. At this point the Switch has stopped charging which to me means the M92 chip has failed. Would explain why the Aliexpress mod chip didn't work because the M92 was already having issues. I found a shorted resistor...
Wish I knew before making all these mistakes. The RP2040-Tiny seems to work and I'm now able to write to the nand without errors. Tried to rebuild the nand after watching the video and I'm still stuck at the Switch logo. This happens with and...
I stopped using that 3.3v point on v1&v2 because it is very fragile. Just go for the 3.3v on nand. it´s a double pad to solder in.Mutch easier and solid work.
1709853459
congratulations, wonderfull work :)
Decided to use a thin wire for the 3.3v connection, because I had a mishap trying to do it with a thicker wire. The wire broke off when I was putting the heatsink back on and ended up cover the area with solder, which when I wicked it away had...
Having a hard time getting the 3.3v line connected. Is there an alternative location for the 3.3v? I found a different location that I think will work for the ground because I'm not a huge fan connecting wires to capacitor locations. I keep...
well, as you can see in the picture you posted, the dat0 clk and cmd points do have 47ohm resistors. It's a good idea to either replace them with 100ohm ones for dat0 and cmd, OR add additional 47 ohm ones on these two points.
I removed the resistor and it was 200 ohm's. I thought it had more resistance in circuit. I had an extra flex cable and tried changing that too. So you think I need another mod chip? I might go with the RP2040-tiny route since waiting for...
I would not follow this video, it complicates things too much. Just follow the guide from here and you are all set: https://gbatemp.net/download/a-definitive-picofly-install-guide.37968/download
And no, you don't need mosfet when you use flex...
It beats waiting for Aliepress to send me another mod chip. This video does say a ribbon cable makes it easier. Do I still need mosfets if I reuse the cable? Is there a better instructional video to do this?
Having issues with my V1 Switch with the Aliexpress hwfly mod chip and I'm getting errors on my Switch. When I checked the resistance values were the following
b = 47 Ohm
d = 0 Ohm
a = 47 Ohm
c = 200 Ohm
I then replaced the d 0 Ohm with a 47...
btw i feel this a good time to remind you guys that sea of thieves was made by rare, who also made DKC1-3 and DK64, alongside banjo kazooie and conker's bad fur day