Recent content by FiXiNGA

  1. FiXiNGA

    XBOX One S Power On and then Off Q9F2

    Okay I have some news but not finished the console. It was a failure of the mosfet Driver for MemIO. I measured the ground but did not know it before having the circuit diagrams. So I swapped the mosfet driver and the memory now getting 1.5V But now the console beeps, light is flashing, NO...
  2. FiXiNGA

    XBOX One S Power On and then Off Q9F2

    Hi, I have a XBOX One S which is beeping, shortly white light and then goes off. I measured all mosfets and observed that the Q9F2 Drain side is deadly shorted. By injecting 2 Amps nothing getting warm. I already pulled the two caps near to Q9F1 and Q9F2 but still shorted. Do you know what...
  3. FiXiNGA

    PS5 interchangeable ram moduls from EDM-010 to EDM-020?

    thanks a lot. So it is a BGA180, as the one you have linked is not available any more I ordered the same from another shop.
  4. FiXiNGA

    PS5 interchangeable ram moduls from EDM-010 to EDM-020?

    Hi again. I now have a console where I have to swap all eight modules to Samsung. Sadly I have no suitable stencil here. Does anyone knows the spec, which bga and which spacing is needed for PS5?
  5. FiXiNGA

    PS5 USB not enabled and no synch

    yes sorry for my bad English. I have seen that the regulator gets warm and measured a short at his output. And the root cause of the short on this output was the cap I marked. After swapping the cap everything runs fine now. The regulator is still the old one since it has no further damage.
  6. FiXiNGA

    PS5 USB not enabled and no synch

    So I have some news. Still not working, Southbridge is re balled but not getting better regarding the USB. What I observed: Diode Reading of 5V Rail is -1.9V. That looks weird to me. Maybe a Regulator or diode is burnt? Stdby voltages are all looking good. Console is starting but ends at the...
  7. FiXiNGA

    PS5 USB not enabled and no synch

    I swapped the WiFi Chip but still no enable for the USB Ports. Next try will be reflowing the Soutbridge cause enable comes from there. Interesting is, that on the transistor circuit in front of the MOSFET enable I did not found 5V or do not know where the high side / switching voltage is coming...
  8. FiXiNGA

    PS5 USB not enabled and no synch

    Okay, I can give it a try and swap with another wifi module from a Donor. Thanks, I will reply if it was the problem
  9. FiXiNGA

    PS5 USB not enabled and no synch

    Hi all, I have a new PS5 on my bench. The console is booting normally but it is not possible to synch a controller and since it was resetet to factory no chance to do anything. No of the USB ports is working. I opened the board an checked all fuses. The mosfets of all USB ports are getting...
  10. FiXiNGA

    Switch Lite automatically starts

    Hi all, I have a real weird Switch Lite on my workbench. It came in cause of Blue Screen of Death. I reballed the APU and RAM and cause of an short I swapped the MAX77620 and 77812 with a new one. The switch is going fine now, I added a new battery, new touchscreen and new LCD display...
  11. FiXiNGA

    PS5 EDM 020 TPM Issue

    No sadly not yet. 1708165781 Okay. I measured around and got 3,3V as well through the PullUp voltage for the Enable line. So I cannot understand what is wrong. The Southbridge ist getting a signal from that TPM. Maybe there is an issue.
  12. FiXiNGA

    PS5 EDM 020 TPM Issue

    Hi, I have a PS5 on my workbench with 2Sec Blod. All voltages look good, RAM and APU are getting warm for 1sek and then shutdown. I read out the errlog as you and only had those two problems: 80800014 TPM 2.0 chip / Power failure 808F0002 TPM 2.0 chip / Power failure I swapped it with a donor...
  13. FiXiNGA

    PS5 UART commands

    Seems that they are married. I swapped with one which has not the same number printed on cause I have no donor with exactly the same available. Since then I got this 8080001A error. So I switched back to the original TPM but still 2 sec BLOD and TPM Power issues mentioned in the errlog.
  14. FiXiNGA

    PS5 UART commands

    I‘m also very interested in the meaning of the error codes for fixing some of my 2sec BLOD EDM020 boards with good voltage readings. On of them where I’m stuck now has only one error: 8080001A Can somebody help me? For info: I swapped the TPM 2.0. Thanks and best regards
  15. FiXiNGA

    What is on the 3.3v rail on EDM-020

    Sorry. Correct, near that you will only find 1.8V for WiFi Module. 3.3V is from the backside directly behind this and is connected to 5V Standby. 1699516173 There is an IC on the back of the HDMI encoder. I had a board where the input and output of this IC was not shorted but defect. Then I got...
See more
General chit-chat
Help Users
  • SylverReZ @ SylverReZ:
    They probably said "Hey, why not we combine the two together and make a 'new' DS to sell".
  • Veho @ Veho:
    It's a DS Lite in a slightly bigger DS Lite shell.
     +1
  • Veho @ Veho:
    It's not a Nintendo / iQue official product, it's a 3rd party custom.
     +1
  • Veho @ Veho:
    Nothing special about it other than it's more comfortable than the Lite
    for people with beefy hands.
     +1
  • Jayro @ Jayro:
    I have yaoi anime hands, very lorge but slender.
  • Jayro @ Jayro:
    I'm Slenderman.
  • Veho @ Veho:
    I have hands.
  • Veho @ Veho:
    king-shark-hand.gif
    +1
  • BakerMan @ BakerMan:
    imagine not having hands, cringe
     +1
  • AncientBoi @ AncientBoi:
    ESPECIALLY for things I do to myself :sad:.. :tpi::rofl2: Or others :shy::blush::evil:
     +1
  • The Real Jdbye @ The Real Jdbye:
    @SylverReZ if you could find a v5 DS ML you would have the best of both worlds since the v5 units had the same backlight brightness levels as the DS Lite unlockable with flashme
  • The Real Jdbye @ The Real Jdbye:
    but that's a long shot
  • The Real Jdbye @ The Real Jdbye:
    i think only the red mario kart edition phat was v5
  • BigOnYa @ BigOnYa:
    A woman with no arms and no legs was sitting on a beach. A man comes along and the woman says, "I've never been hugged before." So the man feels bad and hugs her. She says "Well i've also never been kissed before." So he gives her a kiss on the cheek. She says "Well I've also never been fucked before." So the man picks her up, and throws her in the ocean and says "Now you're fucked."
     +2
  • AncientBoi @ AncientBoi:
    :O:ohnoes::lol::rofl::rofl2:
  • BakerMan @ BakerMan:
    lmao
  • BakerMan @ BakerMan:
    anyways, we need to re-normalize physical media

    if i didn't want my games to be permanent, then i'd rent them
     +1
  • BigOnYa @ BigOnYa:
    Agreed, that why I try to buy all my games on disc, Xbox anyways. Switch games (which I pirate tbh) don't matter much, I stay offline 24/7 anyways.
  • AncientBoi @ AncientBoi:
    I don't pirate them, I Use Them :mellow:. Like I do @BigOnYa 's couch :tpi::evil::rofl2:
     +1
  • cearp @ cearp:
    @BakerMan - you can still "own" digital media, arguably easier and better than physical since you can make copies and backups, as much as you like.

    The issue is DRM
  • cearp @ cearp:
    You can buy drm free games / music / ebooks, and if you keep backups of your data (like documents and family photos etc), then you shouldn't lose the game. but with a disk, your toddler could put it in the toaster and there goes your $60

    :rofl2:
  • cearp @ cearp:
    still, I agree physical media is nice to have. just pointing out the issue is drm
  • rqkaiju2 @ rqkaiju2:
    i like physical media because it actually feels like you own it. thats why i plan on burning music to cds
  • cearp @ cearp:
    It's nice to not have to have a lot of physical things though, saves space
     +1
  • AncientBoi @ AncientBoi:
    Nor clothes 🤮 . Saves on washing them. :D
    AncientBoi @ AncientBoi: Nor clothes 🤮 . Saves on washing them. :D