Recent content by GelmerB

  1. G

    Hacking INSTINCT-NX Chip

    Hey guys, I've got some V6 chips black from a guy and would like to know if I have to update the firmware of them? I can only find v1.3 for the v6s? Or is this also compatible for the V6?
  2. G

    Hacking Hardware Picofly - a HWFLY switch modchip

    Its a v2, does that change anything?
  3. G

    Hacking Hardware Picofly - a HWFLY switch modchip

    I am getting blue flashing light on pico and eventually glitches but takes a while. I used 2x 47ohm resistor on cmd and dat0. any suggestions?
  4. G

    Picofly AIO Thread

    I am getting blue flashing light on pico and then goes 3 times yellow then boots OFW. It glitches sometimes but its not consistent. I've looked over all the connections and they seem solid. Any suggestions? Bad pico board? This is my third install. EDIT: Now its glitching but it takes a while...
  5. G

    Hacking Hardware Picofly - a HWFLY switch modchip

    Alright, so 30AWG kynar for 3.3v and ground is good?
  6. G

    Hacking Hardware Picofly - a HWFLY switch modchip

    Is one quick green flash okay while flashing pico chip? Or do i need to bridge it to get the red flash still? Also, is 40AWG magnet wire too thin or fine for V2/OLED installation?
  7. G

    Picofly AIO Thread

    Is one quick green flash okay? Or do i need to bridge it to get the red flash still?
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    K3Nv2 @ K3Nv2: https://youtube.com/shorts/ykuU8hnotr0?si=HzEN_fL2UyOn35HQ +1