Thanks Yo_Homie, Is there a way to view the current partition table? I do not have L4T so i want to use the same partition that the current Linux Distro lives on without ruining the Android or Lakka partitions.
I installed the triple boot "amsPLUS_v0.14.4_CFW_MultiBoot_inkl_Lakka" from PSXtool.de. I have a running ubuntu install but i don't know if it is L4T. I assume it is because it runs on the switch. Is there a way to verify this? If not, Can I install this on. top of that install? I'm new to linux.
Thanks pcwizard. It seems mattytrog is no longer in the loop. His profle you referenced says he hasn't been active since April, 2020. I don't care if the switch is an offline only unit. I just want to be able to boot into Horizon and play "official" roms on it. I can't seem to find a way to get...
I have a switch i bough from ebay that has corrupt keys. I think the Boot 0 and Boot 1 files are bad but am not sure. at any rate I would like to re-install 10.2.0but can find no way to do it without providing a keys file. Is there anything i can do or is it a lost cause. Everything i have tried...
I have an old trinket m0 that had the original flash. it will not show up in the pc no matter what i do to update it to the latest. I purchased another and have the same issue. How can I re-flash to original trinket stock FW so i can start all over? The new trinket did show up correctly after...
I need a little help. I have never updated my Trinket. I can see that it is [Simple-UF2 v0.9.8r3 - Hakate CTCAer 4.6svc]. There does not seem to be a way to get to the SAMD21 update mode. Can someone provide a little guidance on how i can update to the newest firmware? Thanks
I have not put simple-UF2 on the card. I will try that. meanwhile I am going to re-do the wiring with a 40 AWG instead of 30 AWG.
kynar. thanks.
edit: I put TRINKET_REBUG_SIMPLE_UF2_V098r3 on the chip. can't find anything in the github called "simple-UF2.uf2". let me know which is the correct...
Mattytrog,
I got the Trinket M0. I did as the instructions say and got into Switchboot mode and installed the SWITCHBOOT_TRINKET_JOYCON_VOLUME.uf2software. I installed the chip into the Switch according to the Top Trinket M0 diagram using both straps but none of the Pink arrow add ons except the...
mattytrog, I have SX Pro. I am going to do the Trinkey M0 when it arrives. Is there anything special I need to do to use the payload? It says it is for non-Pro users.