Recent content by MrNatto

  1. MrNatto

    Switch Lite Error Code: 2153-0321

    I'll go over that area this weekend and report back. Thank you.
  2. MrNatto

    Switch Lite Error Code: 2153-0321

    When I turn on my (unmodded) switch lite, after the Nintendo logo it shows “error code: 2153-0321….”. If I plug in a headset into the audio jack and then turn it on, the switch turns on like normal. Once the switch is on and working, if I disconnect the audio jack, I get the “error code...
  3. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Which chip would be acting up? The rp2040 is flashing blue to green, are you talking about a chip on the motherboard?
  4. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Ok. I just tried removing the sd card. I power on, rp2040 glitches to blue, then green, but I still only get a black screen. I hold down the power button for 30 seconds after to make sure it’s powered off.
  5. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Help - I’ve had no problem with my picofly’d lite for months. Today I rebooted the console and the screen stays black. The console is charged, the rp2040 goes blue to green, but nothing shows on the screen. What do I do?
  6. MrNatto

    Failed to Init SD Card w multiple 256gb cards, Works with 64gb

    I didn’t test it before using it, I should’ve. It came from a seller on Amazon with 4.8 stars on 47k reviews, so I would think it is. The card was acting “funny” when I would use it on my pc and when creating the emmunand, it would take 30 seconds longer to be detectable or start a process. I...
  7. MrNatto

    Failed to Init SD Card w multiple 256gb cards, Works with 64gb

    Picofly’d a V2. Using a fat32 1tb san disk as my sd. Created emmunand, booted into atmosphere, t.foil, downloading 60gigs from p.shop, and I get this message. Try to exit out, switch goes to gray screen. Restart v2, it glitches into “failed to init sd card”. Took the sd card out, plugged it into...
  8. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    V2 picofly with hole in heat shield.
  9. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    How did you do that? What gauge wire were you using? I've been a little rough with my lite flex cable, and that hasn't happened yet. I've creased the hell out of it. I'm a little concerned that might be the cause of my glitch consistency.
  10. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Does the led on your rp light up the whole time when it takes 5-30 seconds to glitch, or just towards the end? Sometimes my lite doesn’t glitch into rcm (or seem to turn on). Maybe I’m not waiting long enough for it to glitch?
  11. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    ISSUE: Sometimes my Lite doesn't enter RCM or even turn on when I press the power button. If I take off the back cover and shield and press power their is no light on the led to diagnose. If I disconnect the power and then reconnect the power and press the power button, it goes blue-to-green...
  12. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Issue: I turned on my lite a few times being able to boot into Hekate PL, but now when I press power nothing happens. I take the back cover off, the shield off press the power, nothing. I press power again and the rp2040 goes blue-to-green, and then boots into hekate pl. I put the shield back...
  13. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Another switch lite successfully picofly’d
  14. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Doing an rgh3 on an Xbox 360 is a cheap starter solder project. If you can connect to the c5r35 via, this switch mod looks very doable.
  15. MrNatto

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hello, What thickness of double sided adhesive tape is the best to secure the rp2040 to the switch motherboard? 1mm, 2mm, 3mm, 4mm?
See more
General chit-chat
Help Users
    Psionic Roshambo @ Psionic Roshambo: 90K it's fine lol