Today I have flash with tegra explorer the 18.0 FW , sys and emu mmc ,after flash I try to start and I have error HOS bur not black screen , I try to reflasg with 17.0 and again black screen nothing message ,
I have test the resistor of CMD I...
My switch works well with the chip but from time to time it does not start under hekate, it starts normally, I had used very small enamelled wire, I told myself that I was going to change the wire and I made a huge mistake... I connect point C on...
J'utilise le dernier firmware, mais si je retire complètement le picofly le switch ne démarre pas….
Only boot in hekate with picofly , but impossible to boot in stock or CFW black screen
Hello, I recently installed a picofly, and after my switch no longer worked, then I replaced the CMD resistor and the switch still did not start, out of desperation I therefore reinstalled the picofly, and the switch started on Hekate, but...
How to check the voltage around the MAX chip?
I just reinstalled the Pico Fly
When I start the switchI just reinstalled the Pico Fly
When I turn on the switch, the chip flashes white, then blue, then flashes blue infinity
It’s...
Hello, thank you for your answer,
for the capacitor it is an optical effect because it is intact,
I swap them with an OLED motherboard and still nothing at startup... if you have any other idea or what I can test? Thanks
Hello, I installed a picofly on my OLED switch, and I made a tin ball on several components on the side of the point (B) ( RST) and at first the processor became boiling, then I saw the tin ball in the microscope, so I removed it the processor...