Recent content by Remi63800

  1. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    Have good night and thanks for alls , sorry for all my bad language
  2. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    Yes I use lockpick this morning for reinstall the firmware In 18.0 error when I boot In 17.0 black screen What is discord ? Thanks
  3. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    When I put my black prob on a mass and my red prob on the emmc point I have 0.72v And it’s write dat0 NEW ( iam sorry )
  4. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    I'm really I translate everything you say and I have trouble understanding, how to test the dat0? Thanks
  5. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    Today I have flash with tegra explorer the 18.0 FW , sys and emu mmc ,after flash I try to start and I have error HOS bur not black screen , I try to reflasg with 17.0 and again black screen nothing message , I have test the resistor of CMD I have 4.46 in my multimeter I lost …
  6. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    My switch works well with the chip but from time to time it does not start under hekate, it starts normally, I had used very small enamelled wire, I told myself that I was going to change the wire and I made a huge mistake... I connect point C on point B and since then nothing works, after I...
  7. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    J'utilise le dernier firmware, mais si je retire complètement le picofly le switch ne démarre pas…. Only boot in hekate with picofly , but impossible to boot in stock or CFW black screen
  8. R

    Nintendo switch boot HAKATE but no boot on stock no boot on CFW

    Hello, I recently installed a picofly, and after my switch no longer worked, then I replaced the CMD resistor and the switch still did not start, out of desperation I therefore reinstalled the picofly, and the switch started on Hekate, but impossible to start in OFW or CFw, I have an infinite...
  9. R

    Switch OLED die after pi fly install help please

    How to check the voltage around the MAX chip? I just reinstalled the Pico Fly When I start the switchI just reinstalled the Pico Fly When I turn on the switch, the chip flashes white, then blue, then flashes blue infinity It’s already a better sign, I think, but no image on the...
  10. R

    Switch OLED die after pi fly install help please

    Hello, thank you for your answer, for the capacitor it is an optical effect because it is intact, I swap them with an OLED motherboard and still nothing at startup... if you have any other idea or what I can test? Thanks
  11. R

    Switch OLED die after pi fly install help please

    Hello, I installed a picofly on my OLED switch, and I made a tin ball on several components on the side of the point (B) ( RST) and at first the processor became boiling, then I saw the tin ball in the microscope, so I removed it the processor from the switch is no longer boiling but no sign of...
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    Psionic Roshambo @ Psionic Roshambo: @K3Nv2, try SanDisk format tool?