Search results

  1. jkyoho

    PS5 EDM-010 missing component under HDMI ic chip

    Cant find the YD label one but this one label with 31 is from Rohm part# DTA044EUB https://fscdn.rohm.com/en/products/databook/datasheet/discrete/transistor/digital/dta044eubtl-e.pdf
  2. jkyoho

    Hardware Dead ps5 PSU adp-400gr

    https://www.a-power.com.tw/en/product/download/AP6NA3R5H/datasheet PACKAGE should be TO-252
  3. jkyoho

    Hardware Is the thermal pad on the battery charging chip necessary?

    I notice the 2R2 inductor next to BQ would heat up around 70C when playing&charging, not sure how BQ goes but the thermal pad definitely help
  4. jkyoho

    Picofly AIO Thread

    looks good. top side Extra gnd seems unnecessary though. The two square ground pads under cap could help stopping flex moving Around, I would say keep them.
  5. jkyoho

    Oled Volume Resistor

    doubt that's an inductor but not resistor. Based from OG and lite design, there are always 100~150 ohm resistor on buttons
  6. jkyoho

    Somewhat Confused here?

    delete cfw-syanad entry from hekate_ipl.ini and enable dns_mitmfrom day1, you should be 2steps away from dirty sysnand
  7. jkyoho

    Help Accidently blue screened my switch!!!

    file transfer can be done through Hekate(even from another switch). Boot 0/1 can be generated from emmchhaccgen on PC with prod.key from the Blue screen console. If you can't/don't know how to make unpatched switch into RCM mode, you are on your own.
  8. jkyoho

    Hardware Power supply problem

    Switch battery voltage max out at 4.23v-ish, 3.9v is pretty much closed to 90% charged, NOT VERY LOW. Also If you are expecting 15v goes into the battery terminal, I think you would see some popcorn out of your battery BMS board. This battery designated charging voltage is 4.35v max I believe...
  9. jkyoho

    Help Accidently blue screened my switch!!!

    So you are on HOS FW 18.0.0. Hekate 6.1.1 and AMS 1.7.0prelease should be able to support this verison. I believe you need to rebuild you nand using Tegraexplorer system_wipe to FW18.0.0
  10. jkyoho

    Help Accidently blue screened my switch!!!

    Did you download from Action or just the latest release on 2022 APRIL? Or you can post the system versions nca file name here like this
  11. jkyoho

    Hacking Hardware broke RST point pad on mi switch oled

    https://gbatemp.net/threads/striped-rst-point-pad-what-to-do.615729/ https://gbatemp.net/threads/b-point-issue-after-modding-switch-oled.634181/post-10178895
  12. jkyoho

    Picofly AIO Thread

    I would prefer solder point on back side in between 2 resistor so that the wiring wont seat on top of Nvidia base but outside of the edge
  13. jkyoho

    Picofly AIO Thread

    where is gate line should solder to? The front side rectangle ?
  14. jkyoho

    How can I restore clean NAND from a NAND backup with a lower version then the fuses?

    bottom line, if sysnand is clear why restore? Just keep it up to date if you want to online play anyway.
  15. jkyoho

    Switch OLED Capacitor/Resistor HELP

    0201 resistor; 0402 capacitor 6.3v should work
  16. jkyoho

    Switch OLED Capacitor/Resistor HELP

  17. jkyoho

    RP2040 Flex Pad came off is it B,C or somewhere else

    as long as D point has correct diode reading you are fine. The pad under D label on that resistor is ground point, and can be ignore
  18. jkyoho

    Touchscreen issues in sysnand and emmc

    if cartridge module or touch digitizer replaced and touch stop working/ghost touch, use Hekate touch screen calibration option and check again.
  19. jkyoho

    Hardware Identify the components near the PI3USB switch V2

    red and blue mark capacitors are all 0.1uf choke filter in yellow mark can be found from pic here
  20. jkyoho

    Hardware PS5 HDMI missing components

    yes, size is inch/imperial by default
General chit-chat
Help Users
  • K3Nv2 @ K3Nv2:
    You confuse shooting for milking
     +3
  • K3Nv2 @ K3Nv2:
    @AncientBoi, hasn't shot anything since 1938
     +2
  • AncientBoi @ AncientBoi:
    :rofl2::rofl2::rofl2::rofl2::rofl2:
  • AncientBoi @ AncientBoi:
    I think that was "The great depression" time
  • BigOnYa @ BigOnYa:
    It like one of those fake guns, that shoot, then a flag comes out and says, "splash"
     +2
  • K3Nv2 @ K3Nv2:
    Yeah a world War wasn't going on or anything
  • K3Nv2 @ K3Nv2:
    Americans lied about camps for propaganda
  • Xdqwerty @ Xdqwerty:
    @AncientBoi, where is your gun at?
  • K3Nv2 @ K3Nv2:
    I thought he already showed you his gun
  • BigOnYa @ BigOnYa:
    "This is my rifle, this is my gun. This is for fighting, this is for fun." - Full Metal Jacket
     +1
  • AncientBoi @ AncientBoi:
    We actually said that in Boot Camp, waaay before the movie :mellow:
     +1
  • K3Nv2 @ K3Nv2:
    I gotta raid0 these m.2s yay
  • K3Nv2 @ K3Nv2:
    https://youtu.be/anqTCgHxq6Q?si=7jdeouVDUNYQUDLA
  • BigOnYa @ BigOnYa:
    Do a raid10
  • K3Nv2 @ K3Nv2:
    That's tomorrow
     +1
  • Xdqwerty @ Xdqwerty:
    Yawn
  • BigOnYa @ BigOnYa:
    Damn Wal-Mart has 42" 4k TVs for only $150
  • Xdqwerty @ Xdqwerty:
    @BigOnYa, i bet it will not fit inside your bedroom
  • BigOnYa @ BigOnYa:
    Yea here in North Korea, we are only allowed 1 19" tv per household. And the only channel we get is, MLT (Missile Launch Today)
  • K3Nv2 @ K3Nv2:
    @BigOnYa, doesn't fit in his bedroom he's American
     +1
  • BigOnYa @ BigOnYa:
    I hate ordering stuff online if I can go buy it somewhere close to me, and everywhere anymore will give you a discount only if you order it online, bs. Should be a discount if I go pick it up, not order online.
  • K3Nv2 @ K3Nv2:
    I love it for most things most stores you just shows the receipt online and they scan it
     +1
  • K3Nv2 @ K3Nv2:
    Makes it easy for incompetent restaurant staff that don't know how to hear an order
  • BigOnYa @ BigOnYa:
    Mostly for big purchases, I want it in my hands before I pay. Like a tv, I trust picking it up myself, before I'd trust it being sent thru mail/delivery. (Broken screen, etc) But yea if I can order online, then pickup at store is ok, but not all places offer that.
  • cearp @ cearp:
    > Like a tv, I trust picking it up myself, before I'd trust it being sent thru mail/delivery. (Broken screen, etc)

    Thing is, if you break it driving back to your house, it's your fault. But if the delivery driver damages it, it's not your fault.
     +1
    cearp @ cearp: > Like a tv, I trust picking it up myself, before I'd trust it being sent thru mail/delivery... +1