LOL... I know the resistors need to be used on the install. I was asking, as you chimed in to my quoted question to another member, regarding using the 100 ohm on the dat0 and CLK. My question was specifically for the OLED because its a little different and requires the dat0 adapter. But, it...
are you bridging the 47R resistors for the DAT0 and CMD whed you do these OLEDs?
are you bridging the 47R resistors for the DAT0 and CMD whed you do your OLED Pico mods? Or would it be better to just order stronger resistors and use those... if so what rating do you use or suggest?
apologies, yes, the centimeter is about .4 inches and i can use that with some kapton tape and I figured it was celcius. Is there any reason you wouldn't use a higher air flow speed?
Thanks again!
I bought a box of broken GBA Advance SPs, xboxes and it came with the pokeball 2ds XL -- I couldn't find where on the board a capacitor went bad and before spending who knows how many hours troubleshooting, I called Ninty, gave a "reasonable estimated time of when I purchased it" and the...
The fan replacement is very, very easy BUT if you don't comfortable doing it yourself think of a few scenarios:
1. is your switch soft modded? then send it in. why? Nintendo uses 3rd party labor for repairs, they won't care to do swap out parts like the CPU -- they just want to do the repair...
One centimeter? that's very skinny, like one-tenth of an inch. You said your largets nozzle, so, I'm guessing more around a half inch?
Thanks for replying, I'll be trying this today.
any suggestions for removal of the buttons and usbc port using hot air -- i'm using Celcius temp? I had a horrible time trying to get the buttons and usbc port off the 2040 zero -- for the buttons they finally came off at 280 and the usbc at 300 -- I think I fubar - ed the board though! I bought...
So I read the guide but I'm not using method w/ mosfet; i'm using the flex cable. because the cpu is the same and I'm not using HWLFLY can I just use a V2 ribbon?
The Version 3 ribbon just seems to arc over to reach the HWLFY, I'm obviously team RP2040, and I'm just going to solder to the pins...
I think I flashed to picofly correctly. To do a quick check to see if anything popped up on my PC screen after my flashing attempt I replugged the picofly into my PC. After replugging the picofly into the PC, The blue light came on and then it began blinking yellow -- it blinked yellow six times...
Thanks for the help!
1687890023
I think I flashed to picofly correctly. To do a quick check to see if anything popped up on my PC screen after my flashing attempt I replugged the picofly into my PC. After replugging the picofly into the PC, The blue light came on and then it began blinking...
Seriously... I get an error "
Seriously... I get an error "failed to load PDF document"
1687888111
Seriously... I get an error "failed to load PDF document"
Hi,
may I please have a link to the picofly firmware -- I think its gud for all versions but I have a V1 thats been updated; so I need the firmware for a v1 switch (not old enought to do soft mod)
yo guys the sonic x shadow generations trailer dropped today, and shadow just straight up decided, and i hate (love) to bring this dead meme up, but, it's morbin time