Hardware Nintendo Switch - SD CARD Alternative Points

[poughstings]

On the @mattytrog diagram, it says to solder ground to the screw, but does that mean on the screw itself or one of these bobs of solder

 

[fragged]

On the @mattytrog diagram, it says to solder ground to the screw, but does that mean on the screw itself or one of these bobs of solder
View attachment 312978

Clearly they mean solder to the copper on the screw hole, no one should solder directly to a screw for a GND connection.

 

[shadow294]

On the @mattytrog diagram, it says to solder ground to the screw, but does that mean on the screw itself or one of these bobs of solder
View attachment 312978

where do i solder that too?

 

[poughstings]

My sc card module doesnt have a capacitor, is there a way for me to still hardwire it?

 

[FreeLander]

Thanks. Works fine. Now I'd like to fit it into my switch but was wondering if it's okey to cut from the red line and get rid of the cable. Is it safe to do so?

 

[DeDaMrAz]

This would be all the connections that go under the Tegra SoC.

 

[maxl1300]

Hello. I am looking for a picture of the sd connector with wires attached bc I am not sure with the capacitor (iam reffering to the last picture of the 1st page). Thank you.

 

[Tommy084]

Hello. I am looking for a picture of the sd connector with wires attached bc I am not sure with the capacitor (iam reffering to the last picture of the 1st page). Thank you.