is there a way to unbrick a trinket m0? i dont know if i disconnected while in flashing process, disconnected because it was stormy outside(monitor would lose connection every few seconds), or "double flashed"? the trinket. it was working and i copied over part 1 and 2 onto switchboot drive again instead of latest samd update file.
it is not recognized by the pc anymore properly. i get it in bootloader mode with pressing 2x the reset button, or by holding volume + until steady blinking withe light. when i then connect the switch to the pc i get the message unrecognized device.
ofw: the switch is stuck at second joycon logo unless i get the switch in bootloader mode and connect to the pc.
vol+ and power: the samd preloader also boots but menus dont open and it cant recognize the sd card.....
thx!
edit:
the SD Crad Connector was damaged eventhough it looked perfectly fine. replaced it and now ofw and prebootloadewr, hekate cfw does work properly. i still cant update the trinket. i dont think updating the trinket will be necessary in the future but still. any ideas?
it is not recognized by the pc anymore properly. i get it in bootloader mode with pressing 2x the reset button, or by holding volume + until steady blinking withe light. when i then connect the switch to the pc i get the message unrecognized device.
ofw: the switch is stuck at second joycon logo unless i get the switch in bootloader mode and connect to the pc.
vol+ and power: the samd preloader also boots but menus dont open and it cant recognize the sd card.....
thx!
edit:
the SD Crad Connector was damaged eventhough it looked perfectly fine. replaced it and now ofw and prebootloadewr, hekate cfw does work properly. i still cant update the trinket. i dont think updating the trinket will be necessary in the future but still. any ideas?
Last edited by k28,