When can we expect the v2.6 brother?You need to wait for v2.6
it needs some testing, approximately several days
Sent from my SM-G781B using Tapatalk
When can we expect the v2.6 brother?You need to wait for v2.6
it needs some testing, approximately several days
same, you need to wait for v2.6and is there anyone among you trying to install pi pico? if so can you guide me by what i have no rp2040 zero in my area i found that pi pico
When can we expect the v2.6 brother?
Sent from my SM-G781B using Tapatalk
- unlock through the toolbox breaks BOOT0, you have to either run firmware update or restore clean BOOT0 to fix itHello friends, anyone have a list of the bugs and errors that the picofly old and latest versions may cause?
if this drop continues it's soon therePlease don't throw any rotten fruit or veg at me but that Hwfly for the oled just took (yet another) price drop
Now down to 32.38 UK - starting to get tempted, I think my buying point would be £25, so if there watching this just letting you know
View attachment 363013
I mean, that same listing has 100 pieces at $15/pc. That’s not bad at all.if this drop continues it's soon there
Just Opend my oled and "lucky" me i have s skhnix emmc , i will definetly be looking for e new emmc soon they seem to have issues so maybe it will be a 256 some day.......Personally, I'd rather just replace the chip w\ a bigger one that is already preballed. 256gb from AliE, for around $80 after taxes\shipping. Check the 'emmc upgrade' thread from @binkinator for instructions and my link towards the bottom for purchasing. Especially with an OLED that has a Toshiba.
if this drop continues it's soon there
for me its around 40€ but even if its 25€ i wouldnt bother buying , i like diy way to much :-)Please don't throw any rotten fruit or veg at me but that Hwfly for the oled just took (yet another) price drop
Now down to 32.38 UK - starting to get tempted, I think my buying point would be £25, so if there watching this just letting you know
View attachment 363013
I guess you could use thicker wires, if you were extra careful not to short anything with them.I've seen pictures of some installs using seemingly thick wires. Would it be possible to (comfortably) use 0.6mm enameled wires instead of the suggested 0.2mm? Or would they just get stuck somewhere?
very trueI guess you could use thicker wires, if you were extra careful not to short anything with them.
But the thin wires are just so much easier to handle and place…
When you see it under the microscope you’ll understand.
So it's "just" that thinner wires are easier to use? Would thicker wire just fit without needing to be rerouted?I guess you could use thicker wires, if you were extra careful not to short anything with them.
But the thin wires are just so much easier to handle and place…
When you see it under the microscope you’ll understand.
I mean, that same listing has 100 pieces at $15/pc. That’s not bad at all.
Still looking for advice on this, if anyone has any.After some successful boots, subsequent failure (as a consequence of the horrible hack to the chip), switching to a -ZERO like we should've started with, a further amount of successful boots, and now further subsequent failure... Any ideas?
It blinks orange (D0) currently, and boots without the chip.