I made a file based emunand for Atmosphere - updated it to 11.0.1 firmware.
Then copied the emunand files to my computer.
Opened the enumand files with - NxNandManager v4.1.1
Right Clicked on each BCPKG section and clicked - restore from file.
Once each of the 4 files was done (about 2 seconds each)
I saved the dump to rawnand.bin.
Next I split - the dump like this:
Code:
Open the rawnand.bin file using HxD Hex Editor and go to: Tools => File Tools => Split...
File to split: Should already be populated.
Base name for partial files (incl. path): Give the output file a name and save location, name can be anything for the time being as you will need to rename them later.
Naming pattern for partial files: Leave as default Naming Consecutively.
Size of partial files: Leave as default Custom, change to bytes, enter the following (Very Important): 4294836224
Then click OK to start splitting the files, once completed, rename the split files to full.00.bin to full.07.bin (See above).
To make sure the split files are correct, RIGHT CLICK on the file and check the properties:
The following files should be the following Size: 3.99 GB (4,294,836,224 bytes)
full.00.bin
full.01.bin
full.02.bin
full.03.bin
full.04.bin
full.05.bin
full.06.bin
The last file should have the following Size: 1.12 GB (1,204,682,752 bytes)
full.07.bin
Next copied the files back to my Micro Sd card - /sxos/emunand/ folder (also included boot0.bin and boo1.bin).
Booted SXOS into emunand - and indeed SXOS works and firmware reports as 11.0.1
So no need to do this on your real nand - and I can confirm it works on emunand just fine.
EDIT: Patches also fix icons in tinfoil using modded boot.dat
Last thing Still not working:
SX Save Manager