Installed. Works like a charm. A few tips for installing on a
DOL-101 specifically:
- I don't think you have to actually remove the heatsink. You must remove the screws that go through the heatsink and secure the motherboard to the bottom chassis so you can access the underside of the motherboard. However, you don't need to take the heatsink off the mobo, risking having to replace the thermal pads. Not 100% sure on this as I did remove the heatsink before I realized I did not have to.
- Beware the standoff that mounts right above GP4 installation location. There is not much distance to work with:
View attachment 316538View attachment 316539
- Routing the wires from the underside of the mobo requires minor trimming of the metal chassis so they don't get squished between the motherboard and chassis. You can probably get around this by feeding wires through existing holes in the chassis, but doing so will "tie" the mobo and chassis together and you will be unable to separate them without detaching wires from the pico.
View attachment 316534
Also, there is a GND pin on pico between GP5 and GP6 that I found more convenient than the GND pin shown in the instruction diagram.
I put the pico in the large expansion bay for easy access. Not sure this will ever actually be useful though.