Recent content by cgtchy0412

  1. C

    Nintendo Switch Oled Stuck at Nintendo Logo

    You can try to remove/redo the clk point. First remove it and test again.. if still persisst then remove dat0 point also.
  2. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    its AON 6554
  3. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    or you can do like this, never failed on me.
  4. C

    Picofly AIO Thread

    If you are sure about your wiring and soldering quality then Try to change/replace the pico/modchip (i solved mine with that). That last part is expected, all is like that, so nothing to worry.
  5. C

    Picofly AIO Thread

    Maybe you can try to move all wires on to emmc points.
  6. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    LOL, want to see it performs : ordered in hundreds.. Like a boss.. Hahaha:grog:
  7. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi @abal1000x , I've found an OLED which sometimes can glitch and sometimes cannot .. using an DAT0 adapter.. Continuity is good, but still throws dat0 error code. Just want to know your opinion regarding bellow voltages and ranges test. Can we check it directly on the switch unit to know this...
  8. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    Post some pictures please
  9. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    Based on Firmware 2.75, all 47ohm.. Mariko V2. GOAT.
  10. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    No .. im using green Pi Pico. Maybe with 100ohm dat0 the voltage is on the low side of firmware check so it throws error, as maybe if there is no check inplace it woild boot.. just maybe. 1694271687 At least now its safe to know that pico will go to lowest power mode after glitch. 1694271983...
  11. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    Not sure yet. But both unit are now using 47.. with new firmware they dont raise slow emmc warning at least.
  12. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi @abal1000x , just to inform that i have 2 oled unit that throw dat0 error when using 100ohm.. i replace it with 47ohm and its boots. So this resistor value is still not universal for all cases. Will try 2.75 to see if slow issue and sleep battery drain is better. 1694260740 Firmware is...
  13. C

    Picofly AIO Thread

    Its a DAT0 not conected error. First (Hope) : unsolder the D0 wire from pico, check the wire continuity with ground, if still there then try to resolder it again to pico and try. Last Thing (most likely) : Pull out the mobo. then resolder/refix the DAT0 adapter.
  14. C

    Picofly AIO Thread

    Please be patient, no need to double post.. I already reply on other thread.
  15. C

    Hacking Hardware Picofly - a HWFLY switch modchip

    You already succeed. Firmware will will first check and give error rst not connected (short - short) blinks if nothing is connected, so by this then you know that firmware is already running on pico.
See more
General chit-chat
Help Users
    BigOnYa @ BigOnYa: We all should have free health, dental, vision care, and makes the college kids pay for the...