I installed a Trinket M0 into my Switch last year. I chose to install all wires *except* the Vol + strap (six out of seven wires), as I kept reading how hard it was to get to for some folks, and I didn't mind limited the boot options.
I've noticed that when I have the switch in sleep mode (either in sysnand, or from atmosphere emummc) that it seems to churn through the battery faster than I'd expect; from 100% to 70% in 12 hours. And to 50% after about 20 hours. Is this expected?
If I power off the Switch, battery, it seems to hold power at a 'normal' level.
When I booted into the info screen a couple of months ago, here's what it reported:
Fusee_UF2 Information. V6_110320.
Battery: 31% 3693mV
Following Straps Detected:
JOYCON
USB VOLTAGE
Chip-based autoRCM mode active.
Boot Animation 2 selected.
Screensaver is active
Name your payload(s) as follows:
Location: SD Root.
payload.bin
payload1.bin
bootloader/update.bin
For Kosmos users:
bootloader/update.bin
Can I also check - should I be in `autoRCM mode` **without** the Vol+ Strap? If dual boot is better, and someone can explain how to switch to that mode without a Vol+ strap, I'm happy to try it. Any other questions/suggestions welcome. It's not the end of the world if I lose battery much faster with the Trinket, I'm just not sure if it's meant to be doing that.
I've noticed that when I have the switch in sleep mode (either in sysnand, or from atmosphere emummc) that it seems to churn through the battery faster than I'd expect; from 100% to 70% in 12 hours. And to 50% after about 20 hours. Is this expected?
If I power off the Switch, battery, it seems to hold power at a 'normal' level.
When I booted into the info screen a couple of months ago, here's what it reported:
Fusee_UF2 Information. V6_110320.
Battery: 31% 3693mV
Following Straps Detected:
JOYCON
USB VOLTAGE
Chip-based autoRCM mode active.
Boot Animation 2 selected.
Screensaver is active
Name your payload(s) as follows:
Location: SD Root.
payload.bin
payload1.bin
bootloader/update.bin
For Kosmos users:
bootloader/update.bin
Can I also check - should I be in `autoRCM mode` **without** the Vol+ Strap? If dual boot is better, and someone can explain how to switch to that mode without a Vol+ strap, I'm happy to try it. Any other questions/suggestions welcome. It's not the end of the world if I lose battery much faster with the Trinket, I'm just not sure if it's meant to be doing that.