Hardware fan cabel out

[MooTwoo]

My Wii U had died on me awhile back, and I'm taking it apart to salvage stuff (and delid the APU) but I wanna use the fan for a little mosfet cooler for one of my side projects, and I only know that one pin is 5v, but I can't get any layout to a 2 wire USB power only to work, do I need a USB with one data cable or what, please help!

 

[V10lator]

Not sure what's the question here. Do you need a USB pinout? here is one:

Or do you know nothing about electronics and need to be spoon feeded? If so: The Fan has 3 wires: A red one, a black one and a gray one. The gray one is most likely a PWM signal, so we don't need it. What's left is the red and the black wire.
The red wire should be VCC and the black ground. So connect the red wire to USB VCC and the black one to USB Ground (see the pinout above).
Please note that I'm guessing here: Normally red and black are VCC and ground but not everyone follows this sheme. You would need to measure the pins inside the Wii U to confirm.

Or do you want to control the fan through USB ? In that case you would need some USB fan controller.

 

[MooTwoo]

No, I am a little newer to USB power etc. but I want to power the fan with a USB power. I don' wanna control it VIA usb, I'm fine with it 100% all the time, but I've tried using a ground and VCC USB power cord on the red and black. but it never powers the 5v of the fan, is it not working due to the fact that it's after market. I've tried every config I can with the 3 pins and I can't get it to work.

 

[sombrerosonic]

Question on What exactly your gonna salvage out of the Wii U?

 

[MooTwoo]

Question on What exactly your gonna salvage out of the Wii U?

tbh just the chips and resistors for everything and I wanna use the fan to cool a mosfet on one of my projects

 

[sombrerosonic]

tbh just the chips and resistors for everything and I wanna use the fan to cool a mosfet on one of my projects

This may be stupid BUT dose the Wii still turn on? you could be able to boot it up in recovery mode and restore a NAND

 

[MooTwoo]

This may be stupid BUT dose the Wii still turn on? you could be able to boot it up in recovery mode and restore a NAND

Nope, I've tried everything, I think the APU died. I got the right voltages everywhere, it just never would turn on, so I'm pretty sure the APU overheated or something at one point and fried the Dye

 

[Anxiety_timmy]

Nope, I've tried everything, I think the APU died. I got the right voltages everywhere, it just never would turn on, so I'm pretty sure the APU overheated or something at one point and fried the Dye

Doesn't turn on as it just flashes an led or goes blue but nothing happens?

 

[MooTwoo]

Doesn't turn on as it just flashes an led or goes blue but nothing happens?

Nothing, LEDs don't turn on, nor does the die even warm up, the right voltage goes into it etc. just nothing happens, all the voltages are right, so like I said I think the die fried itself sadly

 

[sombrerosonic]

Nothing, LEDs don't turn on, nor does the die even warm up, the right voltage goes into it etc. just nothing happens, all the voltages are right, so like I said I think the die fried itself sadly

Try to reflow the hardware, then test the caps on the board