Hi, sorry this is kind of a re-post because I have done in the wrong section.
Hope to have more feedback by posting in the correct place.
I installed SX Core and I got the green light and the boot.dat screen.
I started to have problems when I put the SD card with the boot.dat in the switch, because I got a black screen and nothing happened. The chip shows the green light but the Switch doesn't boot.
I disconnected the SX core and connected the NAND in the Switch socket to boot into the origin system.
After this the same black screen happened, I try to turn on the switch and nothing.
Any ideas ? Do I also need to desolder the flex in order to boot into the original system ?
Last night I took a picture of the install and it seems I have bridged a capacitor. Can someone take a look on the picture and see if something is wrong?
Also, the line of caps where the flex is soldered seem to have continuity, is that normal ?
Hope to have more feedback by posting in the correct place.
I installed SX Core and I got the green light and the boot.dat screen.
I started to have problems when I put the SD card with the boot.dat in the switch, because I got a black screen and nothing happened. The chip shows the green light but the Switch doesn't boot.
I disconnected the SX core and connected the NAND in the Switch socket to boot into the origin system.
After this the same black screen happened, I try to turn on the switch and nothing.
Any ideas ? Do I also need to desolder the flex in order to boot into the original system ?
Last night I took a picture of the install and it seems I have bridged a capacitor. Can someone take a look on the picture and see if something is wrong?
Also, the line of caps where the flex is soldered seem to have continuity, is that normal ?
Last edited by sttranger,