I entered rcm mode through the aluminum foil making a jumper between pin 9 and 10 (before I did it with the jig but it stopped working, I imagine the pins were worn out) and then I activated the AutoRCM mode to not use the paper again aliminium It all happened after I updated the switch to the latest version (newbie error) and I couldn't access the RCM anymore, not even with aluminum foil.
PD: the joycons work correctly on the nintendo switch (it makes me doubt that I can't access with the jig but the joycons do work since I understand that the pins are worn out)
PD2: I use hekate as payload and atmosphere as firmware.
PD: the joycons work correctly on the nintendo switch (it makes me doubt that I can't access with the jig but the joycons do work since I understand that the pins are worn out)
PD2: I use hekate as payload and atmosphere as firmware.
Last edited by DestroyerRC,