Hi,
I have a jasper where I have installed a coolrunner rev C.
I wanted to have a dualnand system so I purchased the cheapest chip I could find, the squirt dualnand (512Mb), beside the price, I have used a similar chip (16Mb) on my trinity so I know it works fine.
I found an image on google that explains how to install but I have some doubts since that image is about how to install it with the squirt glitch chip.
1. Can I use the exact same scheme and just connect the GND to my Coolrunner ?
2. Do I need to cut the trace or connect the switch to the trace ? because de picture seems to connect the switch leg to the cutted trace.
3. Any way to test this without cutting the trace ? So that I only cut the trace when I'm sure it will work ?
Thank you all!
I have a jasper where I have installed a coolrunner rev C.
I wanted to have a dualnand system so I purchased the cheapest chip I could find, the squirt dualnand (512Mb), beside the price, I have used a similar chip (16Mb) on my trinity so I know it works fine.
I found an image on google that explains how to install but I have some doubts since that image is about how to install it with the squirt glitch chip.
1. Can I use the exact same scheme and just connect the GND to my Coolrunner ?
2. Do I need to cut the trace or connect the switch to the trace ? because de picture seems to connect the switch leg to the cutted trace.
3. Any way to test this without cutting the trace ? So that I only cut the trace when I'm sure it will work ?
Thank you all!