If you go through the last few pages you will see all the frustration I've had with this. You haven't shown the rest of your solder points, so I can't say for sure. But I will say that I showed extensive pics and many members here agreed I was doing everything correctly yet I still couldn't get it to work.But i have my older firmware dumped thru Gateway and saved on my computer! I have tested the soldering points with an multimeter and everything seems good, but my computer doesnt fins my nand????
May I ask what you did to get it to show up? Be as specific as you can. I've been at it for days.Im getting this error code :
But it's not showing up on my Mac or my PC
EDIT: Reading works fine. Haven't tested writing
YEAHHHH! I got it working and successfully flashed back to my old 4.50 CLK was connected to pin 4 instead of 5 on my sd adapter
May I ask what you did to get it to show up? Be as specific as you can. I've been at it for days.
It only took my 30 minutes lol. I bought a JST SH connector from here : https://www.sparkfun.com/products/10359 It already comes with a female end as well.
I wired the male one(already has wires on it) to the SD card(after cutting it shorter). I then took some ribbon cable and soldered that to the female end and to the solder points on the mother board. Cut a tiny hole in the side of the DS. Connect the JST SH to the SD card and the SD card to a reader. Turn on the DS and youll get a blue screen.
But it's not showing up on my Mac or my PC
EDIT: Reading works fine. Haven't tested writing
I guess I wasn't very specific haha. I mean you couldn't get the NAND to show up on your Mac or PC, but then you edited and said you could.
Referring to this
Oh haha. I did two things wrong. I had CMD and CLK switched and I think(wasnt sure) I had a bad solder point on my female connector bridging DAT0 and CLK.
Congrats. If only I could be this lucky LOL!
EDIT: You say it was connected to pin 4 rather than 5... are you talking about the SD adapter? Because mine is soldered the exact same way yours is...
I used this one! Really Cheap but works good http://www.ebay.com/itm/ALL-IN-1-US...ory_Card_Readers_Adapters&hash=item5d3ebccee5could someone post a link to a sd card reader that has worked for them, i have everything wired up buy the only reader i got is the one in my laptop and doesn't want to play nicely... Thanks
work in progress there is my solder to my board, does it look ok? (all the connections feel strong)
I used this one! Really Cheap but works good http://www.ebay.com/itm/ALL-IN-1-US...ory_Card_Readers_Adapters&hash=item5d3ebccee5
Yes! i counted 5 but it shall be the 4th from right! take an multimeter and check, do it on the pins on the sd adapter , test if the soldering end goes to right end on the pins. its easy to be confused with all numbers.. hope this help, PS: i got the same error code as you get 0000000400 with another sd adaptor before i corrected this.
Thought I would share my build