Use hard surface and steady hand, it cuts like cheeseWould you show me yours?
Use hard surface and steady hand, it cuts like cheeseWould you show me yours?
This is also my preferred way nowUse hard surface and steady hand, it cuts like cheese
No other known issue. You could measure the resistors on board just in case you got lucky and received the revised version with correct resistorsHi. I have just received the rp2040 tiny. I am aware that i should remove the resistors because they have put there ones with 470 ohm instead of 47 and then add those to the board. Is there any other issue regarding the board? I get that the firmware is compatible and there is no other issue?
I have used the search and found nothing else related with that board but as it is not on the guide...
Nop, 470 ohm confirmed. The one for pin 29 is 1kohm. Regarding the firmware i don't need to brindge any pin for the software to "detect" the board?No other known issue. You could measure the resistors on board just in case you got lucky and received the revised version with correct resistors
Also, if you remove them, don't forget to bridge the connections once they are gone.
You only need to remove/replace the ones in redNop, 470 ohm confirmed. The one for pin 29 is 1kohm. Regarding the firmware i don't need to brindge any pin for the software to "detect" the board?
yes, thank you! now i am trying to flash the firmware but no window appears when i connect it to the pc even holding the boot button...You only need to remove/replace the ones in red
Do you get any light? Check the white ffc cable, and the USBC to PC cable aswellyes, thank you! now i am trying to flash the firmware but no window appears when i connect it to the pc even holding the boot button...
yes, on the usb board i get the power light, in red. i will try with another cable...Do you get any light? Check the white ffc cable, and the USBC to PC cable aswell
That should work and 0.2mm (32awg) for mosfets.Which size of magnetic wire is recommended? 0.1mm? 0.2mm? I’m using “regular” wire AWG36 for everything, should I use thicker wire or this size is fine?
Thank you in advanced.
Seems to be usb controller issue.It seems I can't flsh the firmware. I keep getting this error... any idea of the problem?
View attachment 373479
I figured it out. The ffc cable does not fit properly in the conectors... Thank you very much anyways!Seems to be usb controller issue.
Can you try on different pc? Also try disabling antivirus.
You could also try reinstalling the USB Storage controllers from Device Manager.
Now ur getting dirty here ....you show me yours I'll show u mine .....HahahahahahahaWould you show me yours?
Yeah that cable is not wide enough, you have to slot it in just rightI figured it out. The ffc cable does not fit properly in the conectors... Thank you very much anyways!
Are you? I am.