yes master, you are rightyes, but will be hard to fit, very large
yes master, you are rightyes, but will be hard to fit, very large
Yes u will have to install a second MOSFET like @rehius said I had the same issue after installing second MOSFET it worked finecould anyone please help me finding out what's wrong here?
rp2040 seems to glitch successfully, but instead of hekate, it boots directly to Nintendo screen, then after some time a red screen shows up.
I've checked the wiring and soldering, everything seems OK.
Post some photos of your connection. You can also try 94 Ohm (47 + 47).Hello. I'm trying to install picofly on switch v2, but the led on rp2040 first flashes blue, then flashes purple once and boots into ofw. Connections are all checked, soldered to the emmc board and to the main board, tried with and without 47 ohm resistors (ofw won't boot without them).
Pico fw_2.5_nw.uf2 + unlock.uf2 from 78 page
Emmc Toshiba thgbmjg8c2lbail. Switch fw 16.0.1
Have there been any problems with these emmc's?
Can level shifters be used with firmware version 2.5?Post some photos of your connection. You can also try 94 Ohm (47 + 47).
There is a common issue with picofly design - chip works on 3.3v levels, and eMMC has 1.8v, I use some magic to make it working, but in theory you have to use a level shifter
Easy for you to say. They cost thrice the price of the rpi2040 and are hard to get at all here (i.e. aliexpress doesn't even list them from my location).Can people just use the flex cables please? It makes everything easier
sure probaly could , but i wasnt willing to wait 2-4 weeks for a flex cable to arrive some people would wait even longer XdCan people just use the flex cables please? It makes everything easier
Maybe use SN74LV1T34 logic level(3.3v to 1.8v(vcc on 3.3v) solve the problem?Post some photos of your connection. You can also try 94 Ohm (47 + 47).
There is a common issue with picofly design - chip works on 3.3v levels, and eMMC has 1.8v, I use some magic to make it working, but in theory you have to use a level shifter
I think AW39112DNR is more appropriateMaybe use SN74LV1T34 logic level solve the problem?
So..two pins go to logic level shifter?I think AW39112DNR is more appropriate
Looks like only D0 is needed? Or all of them, because the others have pull-up resistors inside,So..two pins go to logic level shifter?
So..two pins go to logic level shifter?what about this i2c logic level?
Post some photos of your connection. You can also try 94 Ohm (47 + 47).
There is a common issue with picofly design - chip works on 3.3v levels, and eMMC has 1.8v, I use some magic to make it working, but in theory you have to use a level shifter
I used the backup BOOT0/1 and the firmware to extract a new BOOT0/1 for recovery, and used the backup NAND for recovery. The problem remains. Is there any other way to repair VOL+?Spoiler: Reboot to OFW / Vol+ & Vol- doesn't work, blue/black screen
Answer:Boot into Full Stock and perform a full system reset.