Oh okay thought u meant on the rpThe one on the board side.ot the one on the rp2040 47OHM.
I knocked of the resistor on the board cmd resistor.
Srry can't tell u that don't have the oled open other wise I would check
Oh okay thought u meant on the rpThe one on the board side.ot the one on the rp2040 47OHM.
I knocked of the resistor on the board cmd resistor.
Beautiful soldering, I would like to use this method too. Are both wires soldered to the CPU of the rp2040? Can these two lines be merged?i did it this way
View attachment 363680
Beautiful soldering, I would like to use this method too. Are both wires soldered to the CPU of the rp2040? Can these two lines be merged?i did it this way
View attachment 363680
I’ve tried make the OFW work using the following:That is why it's alpha, once everything is fixed I post a new version.
fixing this right now, software update related thing.
What about the boot loader? Wouldn’t that need to be updated via USB?Starting with 2.6 alpha, you can just update the chip using a special payload, no need to use USB.
Flashed 2.61 via toolbox
open picofly toolbox
how to access "picofly toolbox"? and what the difference if i run hekate > payloads > click update.bin?Starting with 2.6 alpha, you can just update the chip using a special payload
what is bootloader?What about the boot loader? Wouldn’t that need to be updated via USB?
No problem man,I found that the resistor is a 3.7k ohm.Oh okay thought u meant on the rp
Srry can't tell u that don't have the oled open other wise I would check
4.7k ohm to be clearedNo problem man,I found that the resistor is a 3.7k ohm.
i use usb to flash FW 2.61.uf2 , should i still flash unLock.uf2 ?2.61
- no more magic for xiao/itsy, detection by shorting pins
-- for xiao2040 please short GPIO 1 & 2
-- for itsybitsy please short GPIO 2 & 3
- moved to the latest sdloader version (I know, logo sucks now)
- software update bugfixes, rollback works fine now
update.bin is a few pages back or klick on the top of the thread ther is a field with importend post if u click on fw 2.61 u will get the post shown or u go to th AIO Thread and there are links to everythingdo i rename the 2.6.uf2 to .bin to update? or may i have the update.bin file link please.
noi use usb to flash FW 2.61.uf2 , should i still flash unLock.uf2 ?
yes since its a mariko board u can use V2 cable On v2/Lite/OledGuys, can someone confirm. If i can use the switch v2 flex cable to switch lite?
Ask any Woman if the length mattersGuys Does the length of the wires matter?I saw so many comments that need more length for it to work?
Is it ok to short those two 3.3v points? (I do get continuity between them, but it never hurts to ask about it )I often replace m92t36 so was thinking of using another 3.3v point so to not run wires around m92 incase it ever needs to be replaced
The emmc board has a 3.3v point that I guess sx core and hwfly clones use with the solderless chips
View attachment 363672
AWG36 to be exact.Guys Does the length of the wires matter?I saw so many comments that need more length for it to work?