4.7Kohm 0201 both of themHello, gentlemen, do these two resistors have the same values?
4.7Kohm 0201 both of themHello, gentlemen, do these two resistors have the same values?
The flex v2. V3. Lite Flex. Is same value to sp1 sp2. On nintendo switch lite.???
Thank you brotherYes, you can use V2/3 on v2 switch, lite and oled.
I used 6 2040-tiny today. Three of the switches (V1/V2) of Samsung emmc have emmc slow error.
The revised tiny integrates 45 ohm resistors.With just the integrated 47ohm resistors or have you added one more to dat0 and cmd?
Hmm try a different sd card and windows or Mac?I use and adaptor that came with the micro SD.
The brand it's Kingston Canvas Select Plus.
I'm 99% sure that's not Micro SD fault, because I can get into UMS mode and see the SD card on the PC with USB C on the switch.
I can play with the GPP partitions and the Boot0 and Boot1 too.
I try with exFat and FAT32 too.
The revised tiny integrates 45 ohm resistors.
These resistors usually have a 10% margin of error plus some resistance over the wire itself that changes with length, so 45 and 47 are close enough to make no difference.I thought they were 47 thx. But did you add a “second” resistor to fix slow emmc error?
I have an OLED that has slow glitch times on the Pico too. Are you using mosfets or a HWFLY CPU flex?Im finish install pico fly on my console lite. The pico boot slow. Is there any fix. Im use 3.73 firmware.
Picture of install pleaseIm finish install pico fly on my console lite. The pico boot slow. Is there any fix. Im use 3.73 firmware.
Flex v3I have an OLED that has slow glitch times on the Pico too. Are you using mosfets or a HWFLY CPU flex?
Im finish install pico fly on my console lite. The pico boot slow. Is there any fix. Im use 3.73 firmware.
I have slow glitching Pico too. The resistors are not shorted and the diode readings for those points are in range but the CPU point 15 on the Pico measures 1.119 v which I think is too high as I've heard it should be around 0.500. Do you have any idea what could cause the high reading on CPU point on the Picofly?Check resistors and solder points
Sent from my iPhone using Tapatalk
Im sorry it is first install. And any thing wrong plz told me what I do wrong. Thanks. Im still not soldring Flex legs i was thinking on my console it is new.Picture of install please
Im sorry it is frist install. And any thing wrong plz told me what I do wrong. Thanks. Im still not soldring Flex legs i was thinking on my console it is new.