this has nothing to do with resistor issues.
its just a switch thing some need 100ohm do run properly.
is u put your switch back together completly befor testing then it is ur own fault !!!
with a zero and a tiny u know its works properly with this firmware.
no one has any diagramms from the picofly cloney with clones i mean all other then rp2040 zero/tiny cause thats what the firmware was written for .
Post automatically merged:
did u also add uv mask or whatever that white stuff is under the emmc?
did u flatten the 0.1mm wire? u might be having hight issues what ever ur issue is.
and one tip befor u even start the board clean the flux properly.........
Post automatically merged:
that is no picofly thats a hwfly on some other clone there are threads extra for those clones , this thread is (or used to be )
for original picoflys (Rp2040 Zero/Tiny)
is want any information about that board then ask ur seller on ask in the proper thread............
Post automatically merged:
Permanent Dat0
Where can I buy permanent Dat0 reball adapter? I'm not seeing it on Ali.