Hardware [Question] Soldering the + Button to Also Be Used as a Short Button into RCM?

[Proto-Propski]

Alright quite simple, does anyone know of any pads for the from facing buttons, or have a schematic of solder points. The idea is I'd like to make my + on my Right Joy-Con double as an RCM button, just to keep it looking as visually normal on the outside of the Joy-Con as possible.

Figured I'd move away from just soldering the two pin pads permanently, and I like the idea of a button, but I want it to just blend into the visual design, and a outward shell mod to add a new button would just stand out way too much.

 

[Prime420]

Why you want use the "plus" button?
Just use the eject button. You only need a 2*3*0.6mm button, some wire, a soldering iron and 2 screwdrivers.
When you need a link for 2*3*0.6mm button pm me

https://gbatemp.net/threads/joy-con-mod-eject-button-as-switch-for-rcm.509405/

 

[FAST6191]

Some people were using magnetic switches that can penetrate the case.

Page 2 of
https://github.com/dekuNukem/Nintendo_Switch_Reverse_Engineering/blob/master/joycon_pcb.pdf (larger site https://github.com/dekuNukem/Nintendo_Switch_Reverse_Engineering )
appears to have it (inside top of the joycon, bottom right hand side of the image).

It should be said though that if you are big enough and ugly enough to dream up a mod like this that you could be expected to poke it with a scope or multimeter -- looking at that shot then you could find out in minutes.