Hello guys,
It is my 1st time posting here. I've already found some fixes for my issues here (thanks to y'all btw) so I thought it would be the right place to ask.
Long story short, I tried to mod my brand new OLED switch with a HWFly modchip. I bought 2 different versions to be sure.
The 1st time, I think I did all well but the chip wouldn't boot and the switch was booting normally, not in the "No SD Card" screen. I checked every connection like 10 times so I thought the chip was faulty. I then proceeded to change the ribbons for the other version, but a capacitor broke off during the process (next to the CPU). I put it back in place, the console was working fine after that. I then proceeded to put the new ribbons, all measurements looked good:
A, C, D, 3.3V were 0.75V in diode mode
B was 1.5V
When I tried to boot, the chip made a blue light signal, ther purple, then nothing. I had to unplug and replug the battery to do it again, just for it to do the same pattern.
Then the switch wasn't working anymore, no normal boot at all even without the chip.
My voltages in diode mode were then :
A,C,D 0,45V
3.3V 0.75V
Now, I'm afraid that I killed my CPU; every capcacitor on the picture that is painted in red either show a resistance of 0 or 1ohm between its 2 points:
Do anyone know if it's worth the time to try to repair it, or should I only keep it for parts? Could it be another chip that died?
Thanks by advance for your time !
I'm so devastated
It is my 1st time posting here. I've already found some fixes for my issues here (thanks to y'all btw) so I thought it would be the right place to ask.
Long story short, I tried to mod my brand new OLED switch with a HWFly modchip. I bought 2 different versions to be sure.
The 1st time, I think I did all well but the chip wouldn't boot and the switch was booting normally, not in the "No SD Card" screen. I checked every connection like 10 times so I thought the chip was faulty. I then proceeded to change the ribbons for the other version, but a capacitor broke off during the process (next to the CPU). I put it back in place, the console was working fine after that. I then proceeded to put the new ribbons, all measurements looked good:
A, C, D, 3.3V were 0.75V in diode mode
B was 1.5V
When I tried to boot, the chip made a blue light signal, ther purple, then nothing. I had to unplug and replug the battery to do it again, just for it to do the same pattern.
Then the switch wasn't working anymore, no normal boot at all even without the chip.
My voltages in diode mode were then :
A,C,D 0,45V
3.3V 0.75V
Now, I'm afraid that I killed my CPU; every capcacitor on the picture that is painted in red either show a resistance of 0 or 1ohm between its 2 points:
Do anyone know if it's worth the time to try to repair it, or should I only keep it for parts? Could it be another chip that died?
Thanks by advance for your time !
I'm so devastated