Hello Guys,
I repaired another OLED switch, this time a Zelda edition, but in sleep mode the joycons are jiggling and the battery is draining like hell.
What I already tried:
- I swapped the MB in another oled console and its the same,
- same with another joycons,
- same with different modship (instinct nx and picofly),
- same in CFW or OFW,
- same if I restore the emmc,
- same in airplane mode.
This is what I repaired on this console:
- broken CLK line
- screen connector replaced
- permanent dat0, I reballed 3 times the emmc to try to get rid of this issue
- CMD resistor replaced
On this console the instinct-nx was taking a lot of time to gitch the console, so I replaced it by a Picofly.
But to not have a slow emmc mode I had to add +47ohms on the CMD point, and +3x47ohms on the dat0 point.
I did maybe 30 oled modchips, with only picoflys. Usually I only add +47ohms on the CLK point to not have a emmc slow mode.
I find nothing on internet about this issue.
What could cause this issue ?
Thank you
I repaired another OLED switch, this time a Zelda edition, but in sleep mode the joycons are jiggling and the battery is draining like hell.
What I already tried:
- I swapped the MB in another oled console and its the same,
- same with another joycons,
- same with different modship (instinct nx and picofly),
- same in CFW or OFW,
- same if I restore the emmc,
- same in airplane mode.
This is what I repaired on this console:
- broken CLK line
- screen connector replaced
- permanent dat0, I reballed 3 times the emmc to try to get rid of this issue
- CMD resistor replaced
On this console the instinct-nx was taking a lot of time to gitch the console, so I replaced it by a Picofly.
But to not have a slow emmc mode I had to add +47ohms on the CMD point, and +3x47ohms on the dat0 point.
I did maybe 30 oled modchips, with only picoflys. Usually I only add +47ohms on the CLK point to not have a emmc slow mode.
I find nothing on internet about this issue.
What could cause this issue ?
Thank you
