Switch does not charge ofw or cfw after changing battery

adrixstile12

Member
OP
Newcomer
Joined
Nov 23, 2016
Messages
7
Trophies
0
Age
25
XP
84
Country
Hello, yesterday I changed the battery and left it charging but now I find that neither CFW nor OFW starts, I directly turn it on and it doesn't start. I have RCM disabled and I can load payloads from Tegra, if I leave the SD connected it won't let me inject any payload but if I remove it, it does start. I have tried formatting the SD and loading the latest version of Atmosphere. Another thing is that if I start Hekate without the SD but insert it after loading Hekate does detect me and I can see the payloads that I have inside it. Once inside Hekate it appears Battery: 0.0% (0 mV) - Charge: 0 mA. I have the console in update 17. I have tried another SD that I have but it doesn't work either.



1.jpg
2.jpg
3.jpg
 

BigOnYa

Has A Very Big
Member
Joined
Jan 11, 2021
Messages
3,224
Trophies
1
Age
50
XP
7,607
Country
United States
Try running the Switch thru two or more charge cycles (Full discharge till it shuts off itself, then full recharge to 100% plus an hour or two.) inside HOS, or OFW, not CFW. After a few charge cycles, the switch should calibrate the battery by itself. Then once battery is synced, re-enable AutoRCM and CFW.
 

adrixstile12

Member
OP
Newcomer
Joined
Nov 23, 2016
Messages
7
Trophies
0
Age
25
XP
84
Country
Try running the Switch thru two or more charge cycles (Full discharge till it shuts off itself, then full recharge to 100% plus an hour or two.) inside HOS, or OFW, not CFW. After a few charge cycles, the switch should calibrate the battery by itself. Then once battery is synced, re-enable AutoRCM and CFW.
The problem is that I can't enter either OFW or CFW. Only enter Hekate without SD while booting, only after Hekate loads
 

BigOnYa

Has A Very Big
Member
Joined
Jan 11, 2021
Messages
3,224
Trophies
1
Age
50
XP
7,607
Country
United States
The problem is that I can't enter either OFW or CFW. Only enter Hekate without SD while booting, only after Hekate loads
Have you tried starting it in Maintance mode once? Once the console is fully turned off, press and hold both the Volume Up and Volume Down buttons at the same time, then press the Power button too. Once booted into Maintance mode, just press power to turn off. Then try normal start.
 

Site & Scene News

Popular threads in this forum

General chit-chat
Help Users
    SylverReZ @ SylverReZ: :rofl2: