Hacking Accidentally Removed Solder Pad

[CoffeeOwl88]

I accidentally removed a solder pad from my RP2040 Oled ribbon. I don't have another ribbon to use and don't have the skills to repair that solder pad. What else can I wire that resistor to instead?

 

[xawak67952]

it isn't connected anywhere. The pad was here just to hold FPCB in place

 

[CoffeeOwl88]

it isn't connected anywhere. The pad was here just to hold FPCB in place

Really?? Well thanks, that's good news!

 

[Hayato213]

did you knock off component in the red circle that you circled?

 

[impeeza]

nop is an anchor point of the OLED ribbon

but, I also am worried about the SOC component on which the ribbon will be anchored, seems from the first picture something is missing or damaged.

 

[superfiege]

Im not sure but I think you bridged D-point to ground!!! I recommend to measure before powering your OLED.

 

[jkyoho]

thats just ground pad on that resistor pad far from cpu, and yea I think op bridged GROUND and CLK together .

 

[superfiege]

Im also not sure if I see it right on the picture but I think that the D-point (clk) is not grinded and soldered?

 

[CoffeeOwl88]

thats just ground pad on that resistor pad far from cpu, and yea I think op bridged GROUND and CLK together .

View attachment 425496

Thanks, I did go back and fix that.

 

[superfiege]

does your switch modchip installation work now?

 

[CoffeeOwl88]

It does, although I ran into another issue but I'm about to make another thread about that, thank you.