Hi all,
Looking for some advice on a HWFLY v5 install + reed switch.
The install went well on a Zelda OLED and was successful. However I'm having issues with the HWFLY v5 chip. - It seems to be stuck in training mode. - I power the console on, the chip turns solid yellow, then turns off and sysnand boots. If I hold a magnet next to the reed switch, the HWFLY will then flash purple many times, then green and boot in to hekate every time. - I thought it might have been an issue with the reed switch so I tested a different reed switch and I got the same result. Power console on, solid yellow, then goes off and loads sysnand. Power on with magnet, purples purple, then green and goes in to hekate. - I even removed the reed switch and the hwfly goes solid yellow, off, then boots sysnand. I did reach out to hwfly team and they advised me to flash the hwfly with: hwfly-0.71-p2-sx I did this and the result is the same with reed switch connected. - Power console on, goes yellow, then boots sysnand. - Power console on with magnet, purples purple, then green, then to hekate. I'm just wondering if anyone has any advice?
These are all of my values:
3v3- 0.127-0.129
C-0.525
A-0.518
D-0.495
B-0.016
Any advice would be much appreciated.
Looking for some advice on a HWFLY v5 install + reed switch.
The install went well on a Zelda OLED and was successful. However I'm having issues with the HWFLY v5 chip. - It seems to be stuck in training mode. - I power the console on, the chip turns solid yellow, then turns off and sysnand boots. If I hold a magnet next to the reed switch, the HWFLY will then flash purple many times, then green and boot in to hekate every time. - I thought it might have been an issue with the reed switch so I tested a different reed switch and I got the same result. Power console on, solid yellow, then goes off and loads sysnand. Power on with magnet, purples purple, then green and goes in to hekate. - I even removed the reed switch and the hwfly goes solid yellow, off, then boots sysnand. I did reach out to hwfly team and they advised me to flash the hwfly with: hwfly-0.71-p2-sx I did this and the result is the same with reed switch connected. - Power console on, goes yellow, then boots sysnand. - Power console on with magnet, purples purple, then green, then to hekate. I'm just wondering if anyone has any advice?
These are all of my values:
3v3- 0.127-0.129
C-0.525
A-0.518
D-0.495
B-0.016
Any advice would be much appreciated.
Last edited by jellybeangreen2,