MAX8969 5.0V Output Chip, instead of 5.3V

[Harak]

Hello,

wanted to ask, if it is possible to use the 5.0V Version of the MAX8969 Chip, instead of 5.3V because there is no 5.3V at Mouser. Perhaps somebody used it already. I need to replace this chip, because fan and Joycon detection is not working with my console.

Thanks

 

[WigWrm]

Any type of 5V CMOS logic would dictate that a voltage greater than 3.5V is seen as a "hi" logic signal. So does the extra 300mV really matter that much?

I can't say I really understand why 5.3V output is an industry standard. But I wouldn't imagine that using the 5V output version of the regulator is going to cause any problems.

 

[Harak]

I will try it, Hope it fixes the issue and give an answer to that. I was thinking the same tbh.

 

[Harak]

Its workin. At least the fans. My Problem with the Joycons not connecting still persist