Hi all, newbie here.
I have done several mods on V1, V2 but this was my 1st time doing OLED. After installing PicoFly I was happy to see "Insert SD card" and Raspberry logo, I inserted the microSD turned on the console, booted into Hekate and then after fully assembling the Switch, it only booted into OFW, with Raspberry pico LED blinking reporting DAT0 is not present, also OFW would occasionally stop working and had to unplug and replug the battery. Later on, it stopped booting completely. I was correct to suspect a cracked joint under the eMMC, but was not expecting a missing pad on the PCB
My question is, if I happen to somehow reball the eMMC chip and put it back, would it still boot? I tried looking for the datasheet but can't seem to find any that shows if this is just another GND point, or is it something of importance on that tiny pad.
Thanks, everybody! I appreciate your insights.
I have done several mods on V1, V2 but this was my 1st time doing OLED. After installing PicoFly I was happy to see "Insert SD card" and Raspberry logo, I inserted the microSD turned on the console, booted into Hekate and then after fully assembling the Switch, it only booted into OFW, with Raspberry pico LED blinking reporting DAT0 is not present, also OFW would occasionally stop working and had to unplug and replug the battery. Later on, it stopped booting completely. I was correct to suspect a cracked joint under the eMMC, but was not expecting a missing pad on the PCB
My question is, if I happen to somehow reball the eMMC chip and put it back, would it still boot? I tried looking for the datasheet but can't seem to find any that shows if this is just another GND point, or is it something of importance on that tiny pad.
Thanks, everybody! I appreciate your insights.