i have 0.3
--------------------- MERGED ---------------------------
even with the standart v2 a9lh
--------------------- MERGED ---------------------------
even with the standart v2 a9lh
I made a post above about upgrading from 0.3. There was a problem with running SafeA9LHInstaller after 3DSafe. You need to enter your PIN, run Decrypt9, restore a NAND backup with normal A9LH, then run SafeA9LHInstaller and install 3DSafe 0.4.i have 0.3
--------------------- MERGED ---------------------------
even with the standart v2 a9lh
I'm not sure actually. I think the titles are on the SD card. However, there is a way around this. Here's what to do:oh i have a problem i have a a9lh backup with no games installed and one after 3dssafe 0.3 installed.
i dont want to lose my games
--------------------- MERGED ---------------------------
i am loosing my games if i restore the a9lhed backup (without games) ok the games are on sd but the restored nand cant read them right?
Excellent! I should add that the reason this will work is that Decrypt9 overwrites the A9LH payload, but Hourglass9 doesn't. So you can use both apps as I described to switch the A9LH payload while keeping the same NAND contents. And yes, once you're on 3DSafe 0.4 you can remove SafeA9LHInstaller payload from the Luma folder as 3DSafe provides it.cool i have backup of both on my sd
--------------------- MERGED ---------------------------
that means i can delete safeA9LHinstaller of lumas payload folder?
Please let me know how it goesok i am doing it right know
No idea sorry. I don't even know what they are. I don't think it's related to 3DSafe though so better to start a new threadok
--------------------- MERGED ---------------------------
one question: luma3ds can load cro files (used for pkmn oras hacks)
do you know where to get these ? because i never heard of .CRO files before
That's ok buddy How's the NAND restore going?sry xD ok i ask somewere else
Ok, just remember to switch to hourglass9 before restoring your NAND with the games on otherwise you'll end up with 3DSafe 0.3 againits restoring (original a9lh) its at 43 percent
I think that if you enable the keep a9lh option then it will leave whatever payload is already there in NAND (in this case 3DSafe 0.3) but if you disable it then it will restore the whole NAND including whatever A9LH payload is already there in the backup. If you're certain that the backup has A9LH then I believe you should disable the keep a9lh option. Let me double check that and get back to you.yeah i know that xD
--------------------- MERGED ---------------------------
have to do it again. in decrypt9 should i use the NAND restore (keep a9lh) option?
I just put the files in a9lh folder and installed them with safea9lhupdaterWell I know what it is, I just haven't read it.
What did you do?
Yes.
Do you already have 3DSafe installed? If so what version?
I have no idea why that would brick. What hardware are you running on?I just put the files in a9lh folder and installed them with safea9lhupdater