I've been a very happy customer of the v19 DragonInjector since release, but recently I started experiencing issues. When I plug the injector into my Switch, the DI LED will very quickly flash red, then blue for about 1 second, and repeat that cycle over and over. My Switch's screen remains black, no text appears that it is loading a payload.
I connected the DI to my computer; no firmware updates were available. I keep my DI in single payload mode. The issue has happened with multiple payloads, and I've double checked that the payloads are not affected by an archive bit.
Any ideas? Did I accidentally break my DI somehow? Thanks!
I've seen a few units have the pressure on the battery loosen over time due to the copper battery contact flattening out, in all but one case tightening up the screw a bit fixed the issue. You'll know if that's the cause by gently pinching the DI while injecting - if that fixes it, it's just a battery connection issue.
I have had one other person report a similar issue that turned out that they somehow managed to mess with the USB calibration registers on the MCU - leaving the DI plugged in for a minute or two with the red/blue LED cycle caused it to eventually recalibrate and work properly.
If you try both of these and it doesn't fix the issue please let me know!