- Joined
- Jun 25, 2010
- Messages
- 1,096
- Trophies
- 1
- Location
- Your computer's Recycle Bin
- Website
- www.google.com
- XP
- 1,942
- Country
I have this switch that was given to me because it wouldn't boot or give signs of life. (probably the nand got badly corrupt)
I managed to boot it to RCM and install atmosphere and autorcm, all this without a working screen ( I may have shorted the screen ribbon and something is broken on the board)
Anyway, today the switch was probably out of battery and I recharged it and went to push the fusee payload from my pc.
The switch is dead, as in, my pc does not show any device connected. But it is charging ok because I have a power meter.
I tried using a rcm jig and holding + and power. No luck. Tried removing the battery, no luck.
I hear some "speaker pop/noise" so it is powering something up, but on the usb side shows nothing.
Any tips?
Edit 1:
Switch enters in RCM without NAND plugged in
I managed to boot it to RCM and install atmosphere and autorcm, all this without a working screen ( I may have shorted the screen ribbon and something is broken on the board)
Anyway, today the switch was probably out of battery and I recharged it and went to push the fusee payload from my pc.
The switch is dead, as in, my pc does not show any device connected. But it is charging ok because I have a power meter.
I tried using a rcm jig and holding + and power. No luck. Tried removing the battery, no luck.
I hear some "speaker pop/noise" so it is powering something up, but on the usb side shows nothing.
Any tips?
Edit 1:
Switch enters in RCM without NAND plugged in
Last edited by dicamarques,