Emulation GBA Ez Flash Omega and IPS v2 screen

[simcal]

Hello everyone and happy new year, first post here.

I'm writing you because I have a problem with my freshly modded GBA with Funnyplaying IPS v2 screen and Clean Juice usb-c battery. The GBA works perfectly with all cartridges but the Ez Flash Omega, because I get a white screen every time I try to load a game (GB, GBC or GBA). The only way I get to play games is if I copy them to NOR memory.

I upgraded the firmware to the v09 version, and the Ez Flash works smoothly on any other unmodded device. I also checked the "Basic Repair Guide of Current EZ-FLASH Products" thread (point n°9) and started it in Safe mode but I get no errors. What else should I try?

Thanks in advance, best regards!

 

[moon_rabbit]

Have you replaced gba's electrolytic capacitors?

If you haven't replaced it, google the gba capacitor and try replacing it.

 

[simcal]

Have you replaced gba's electrolytic capacitors?

If you haven't replaced it, google the gba capacitor and try replacing it.

Thanks, I will try that. Is it an easy mod? I just started using a soldering iron by doing the brightness control on the Ips (successfully yay!)

 

[Jayro]

Turn the screen down to it's lowest setting when you load a game. It worked for my EZ-Flash Jr on my modded GBC when I had problems, and it worked fine because the screen being set low gave the cart the power it needed.