Ok, tragedy struck.
My fault for not listening to advices about wires thickness and stuff, I ended up buying a 0.35mm wire, which was indeed too thick. Tried stuff anyway but it was a bad idea. I bridged the 3v3 capacitor with the one just above it and in the attempt of cleaning the small bridge, something weird happened and I tried to take a pic in the best way my phone could.
The bridge is now clean BUT a very small stain of solder is now attached to the microscopic capacitor to the right. I can't manage to get it off, it's also lying very low as if it was a very thin layer of solder directly on the pcb.
I suspect it may be caused by a residue of a desoldering wick or a tiny part that came off from the 3v3 capacitor.
At the moment, doing a continuity test doesn't trigger any result, concerning the sorrounding components.
If someone with more knowledge could help me with the following:
- Understand if there's indeed no short due to the blob of solder and subsequently just leave it there with maybe a small dab of hot glue
- Understand if the 3v3 cap is still working and is still well attached to the pcb, because I don't know about another test point (maybe the one beneath the emmc? But still it's quite hard to reach)
- When will it be safe to turn the Switch on again. Of course the battery has been detached since the removal of the backplate.
Hopefully, someone will be able to help
Edit: It's a patched V1
View attachment 363402