Of course I can't have a peaceful install.Is there any actual problem with having the two 3.3v caps soldered together on oled Switch? I ended up bridging them and have been trying to remove the solder without success.
However, they're already on the same line, right?
Shouldn't it be fine as long as I don't short the leftmost one with the gnd from the little cap below?
Soldered the wire back on both capacitors but I ended up getting a VERY sketchy diode mode reading, about only 0.065 of voltage drop, while I had 0.830~ before.
That makes me think that I have a short somewhere, but I just can't find it.
I made some pictures of the area (also one with a syringe needle to show that there's some distance between the 3.3v cap and gnd).
What's bugging me is that there's something looking like mild trace rot in front of the 3.3v points, maybe because I tried too hard to desolder them.
Any ideas? I should I proceed to address this issue? I've thought about air reflowing the area but I'm waiting for some input before I do any further damage