My sons ps2 died, it stopped reading discs. So, I replaced it with a PS3, about a week later I decided to run it wired to my BT smart hub. All was fine for a day or so until the controllers failed to sync. I tried to connect wirelessly and nothing.
So far I have done a complete reset, it ran for 18 hours, upon completion it was able to see my bt hub and connect , then after a few minutes it went back to not being able to connect. I tried another full reset but this time it didnt work.
To me this looks software related, or settings related (im not savvy to these things) as a dull reset did fix it the first time around.
If I try to connect on Easy mode it just hangs there checking network configuration.
If I go custom I get to 'scan' then get this,
If I hit circle and try again I get this,
My son is six and there is a fair chance he may have adjusted some settings without knowing he did it, but would this have carried over on a factory reset?
If it is hardware related I believe the wifi/BT is on a module on the mother board and not a seperate card , I also believe there are two antennas , could the issue be with the antennas?
The unit also seems to be getting hot, just towards the very back , at the top and bottom, is this normal?
Any help would be greatly appreciated.
So far I have done a complete reset, it ran for 18 hours, upon completion it was able to see my bt hub and connect , then after a few minutes it went back to not being able to connect. I tried another full reset but this time it didnt work.
To me this looks software related, or settings related (im not savvy to these things) as a dull reset did fix it the first time around.
If I try to connect on Easy mode it just hangs there checking network configuration.
If I go custom I get to 'scan' then get this,
If I hit circle and try again I get this,
My son is six and there is a fair chance he may have adjusted some settings without knowing he did it, but would this have carried over on a factory reset?
If it is hardware related I believe the wifi/BT is on a module on the mother board and not a seperate card , I also believe there are two antennas , could the issue be with the antennas?
The unit also seems to be getting hot, just towards the very back , at the top and bottom, is this normal?
Any help would be greatly appreciated.