Last week I managed to install the picofly on my Switch Oled (well, it's working, even though I killed the SP2 capacitor), however during assembly I noticed that the measurement for the 3.3v point was approximately 1.05 instead of the range of 0.5~0.8, even though the chip was receiving 3.3v normally and it worked, I ended up leaving it alone, but I had it in my head and today I took the flat out to take a look and apparently everything is normal, even so the measurement is 1.05. The Switch is working normally. I ended up ordering the SP2 capacitor from Aliexpress and I can try to fix both at the same time.... does anyone know what it could be? Is it okay to leave it like this?