The offset is in the filename.@mattytrog: Could you please do me a favor?
I tried to edit the uf2 chainloader file to have mode 8 active where i have the autoincrease and payloads 1,2 and 3 but with my hexeditor on OSX there seems to be a problem because at the offset where to set the mode as described at page on it shows me 00 but that should be 01 if i got the tutorial right. Or is the offset 4AF8 incorrect?
So could you please create the chainloader file for me with 0 folder used and mode 8? I would be very happy if you could do that because it‘s the only thing i need to have my console be able to boot 3 payloads
And could you upload a screenshot of the hex editor showing the offset because the picture that were included in the first post isn‘t there anymore since the update of the method? Because then i could compare it to the view i get and maybe i find my mistake.
Thanks in advance.
EDIT: Used Bootloader 1 with joycon only and Chainloader_0_folder.uf2
Can you short the pin?
Or use the experimental one maybe?
Yes I'll sort you out when I get home
--------------------- MERGED ---------------------------
@mattytrog: Could you please do me a favor?
I tried to edit the uf2 chainloader file to have mode 8 active where i have the autoincrease and payloads 1,2 and 3 but with my hexeditor on OSX there seems to be a problem because at the offset where to set the mode as described at page on it shows me 00 but that should be 01 if i got the tutorial right. Or is the offset 4AF8 incorrect?
So could you please create the chainloader file for me with 0 folder used and mode 8? I would be very happy if you could do that because it‘s the only thing i need to have my console be able to boot 3 payloads
And could you upload a screenshot of the hex editor showing the offset because the picture that were included in the first post isn‘t there anymore since the update of the method? Because then i could compare it to the view i get and maybe i find my mistake.
Thanks in advance.
EDIT: Used Bootloader 1 with joycon only and Chainloader_0_folder.uf2
EDIT2: I used the zip from the other thread and not from this. Is that the problem and because of that the offset is not correct?
Can i use the File linked here together with the bootloader file from the hardware thread (thread where solder diagrams etc. are)?
That‘s all a bit confusing because the hardware thread has a zip with 4 files in it (2 bootloader and 2 chainloader) but that seems to be different files as linked in first post of this thread here.
It is confusing.
I've been limited on time.
I'm going to level the playing field this afternoon and make sure everything is working.