Hey im not sure how to send a message on here but i would like to have my Xbox 360 flashed i have a DG-16D5S, 1175 i took apart the xbox already so can you also tell me what to send in the mail by private message please?Yep, works no prob.
Did it lots of times.
You see that he posted yesterday in this thread?You realize this thread hasn't been touched since 2012, right?
thanks but either I have to program it or I have done something wrong.I don't believe you need to program the Ace.
Also, make sure you unsolder the NAND dumper before booting the 360 (or atleast disconnect the dump wires from the dumper board.
I hear some people I can use an LPT cable to program the ace but not a mtx. Do you know if a lpt works flawless? Or any other method?Seems that Ace chips are preprogrammed for Corona 360's.
You'll have to program Jasper timings to the chip then.
It doesn't have "programmer cables" but it has the programmer headers on the left side of the picture above.You should be able to program it with the MTX if it's got a programmer cable.
Get a coolrunner rev 3 and RGH 1.2 it.I flashed it with a JR now but no timings seem to fit. I got it to boot a couple of times but maybe only 4 boots in 4-5 hours.
Is there a magic timing file you know of for jasper+ace360v3?
Get a coolrunner rev 3 and RGH 1.2 it.
Are Ace chips RGH 1.2 compatible?There's no "magic" timing file.
It all just comes down to wirelength and getting rid of interference.
Make sure your reset wire isn't running near any MOSFETs and make sure it isn't to long
Not needed, Ace chips work extremely well.